Axisflying Argus Plug and Play F7 Flight Controller (STM32F722) 16MB Blackbox, Dual BEC, X8 Support

Overview

Axisflying Argus Plug and Play F7 Flight Controller is an F7 (STM32F722) FC designed for plug-and-play FPV/drone builds, with support for direct connection of common peripherals including HD air units (including DJI O3 Air Unit), analog camera systems, and GPS. The Argus electronics series includes ESC, FC and stack options, with ESC variants listed as 55A or 65A BLHeli 32-bit 3-6S and 96 kHz operation.

Key Features

• IP54 dustproof and splash-resistant design; do not immerse in water or use underwater.
• CNC full aluminum cover design (described for enhanced heat dissipation and stability).
• Large-size MOSFET selection (described for low internal resistance and lower heat generation).
• Plug-and-play connections to reduce/avoid soldering for common peripherals (HD air unit, analog camera, GPS).
• Integrated dual BEC: 5V @ 2A and 9V @ 2A.
• Supports up to 8 motor outputs (X8 PWM supported).
• Status indicator lights for quick working-state checks.
• INAV supported.
• ESC sensor supported.
• RGB LED strip and beeper supported.

Specifications

For wiring, firmware, and build compatibility questions, contact support@rcdrone.top or visit https://rcdrone.top/.

Applications

• Plug-and-play FPV drone builds requiring F7 control and multi-peripheral support
• X8 motor-output configurations
• Builds using HD air units (including DJI O3 Air Unit) or analog video systems
• GPS-enabled INAV builds

Details

The Argus Pro plug-and-play F7 stack uses a CNC aluminum shell and is labeled IP54 dustproof and splashproof for added protection.

Axisflying Argus Plug and Play F7 flight controller features a CNC aluminum protective cover designed to resist dirt and improve heat dissipation.

The Axisflying Argus plug-and-play flight controller uses inline, solder-free connectors and supports direct wiring to a DJI O3 Air Unit with integrated dual BEC power.

The Axisflying Argus F7 stack pairs an STM32F722 flight controller with 16MB blackbox and 30.5×30.5mm mounting, plus a 55A/65A AM32 ESC for 3–6S builds.

The Argus Plug and Play F7 flight controller includes clearly labeled pads and connectors for receiver, GPS, DJI Air Unit, analog camera/VTX, and 4-in-1 ESC wiring.

Factory Betaflight port mapping lists UART1 for MSP, UART2 for receiver, UART3 for GPS, and UART4 for ESC, with labeled motor, telemetry, current-sense, and power pads for wiring.

Betaflight setup guidance covers FC yaw orientation, selecting Serial Receiver Provider (CRSF), and reversed motor direction in the mixer.

Betaflight X8 motor setup steps walk you through selecting the OCTO X8 mixer and adjusting motor order and rotation direction.

The package list details the included wiring harnesses (FC-ESC, GPS, DJI Air Unit, receiver, camera/VTX), rubber rings, screws, and a 35V 470uF capacitor, along with a 400 current scale setting for OSD calibration.