• iFlight GM110-8 Encoder Combo Set (AS5048A), iFlight GM110-8 encoder combo set with three GM110-8 motors, encoder boards, wiring leads, and control PCB
  • iFlight GM110-8 Encoder Combo Set (AS5048A), iFlight GM110-8 motor from the encoder combo set, black housing with POWER MOTOR GM110-8 label
  • iFlight GM110-8 Encoder Combo Set (AS5048A), iFlight GM110-8 AS5048A encoder combo set with main controller PCB, USB port, and small sensor board
1 3

iFlight GM110-8 Encoder Combo Set (AS5048A) - 3x 110mm Gimbal Motors + Alexmos 32BIT BGC Board

iFlight GM110-8 Encoder Combo Set (AS5048A) - 3x 110mm Gimbal Motors + Alexmos 32BIT BGC Board

iFlight

$735.99 USD
$735.99 USD
Sale Sold out
Taxes included. Shipping calculated at checkout.
  • PayPal
  • Visa
  • Mastercard
  • American Express
  • JCB
  • Discover
  • Diners Club
  • Google Pay
  • Apple Pay
View full details

Overview

The iFlight GM110-8 Encoder Combo Set is a brushless gimbal motor and controller kit that adds encoders to each motor so the gimbal control system can track motor position more accurately for improved stabilization and battery efficiency. In a 3-axis stabilization gimbal, passive inertial stabilization depends on good camera balance on the pan, tilt, and roll axes, while active stabilization uses sensors to measure motion and drive motors on all three axes to counteract that motion.

Key Features

  • Easy gimbal tuning; reduced calibration work
  • Power saving; stated working time up to 5 times longer than a gimbal without an encoder system
  • Twin IMUs
  • Faster response; motor torque increases instantly; improved handling of difficult rotation angles
  • Encoder chip: AS5048A

For compatibility and setup questions (motors, encoder board, wiring), contact support at https://rcdrone.top/ or support@rcdrone.top.

Specifications

Model GM110-8
Motor Out Diameter Φ110 ±0.05 mm
Configuration 24N/28P
Motor Height 33.9 ±0.2 mm (included with encoder housing)
Hollow Shaft (OD) N/A
Hollow Shaft (ID) N/A
Wire Length 610 ±3 mm
Cable AWG #24
Motor Weight 610 ±3 g
Wire plug 2.5 mm dupont connector
No-load current 0.09 ±0.1 A
No-load volts 20 V
No-load RPM 125~139 RPM
Load current 2 A
Load volts 20 V
Load torque (g) 8000-12000
Motor internal resistance 20.19 Ω ±5% (resistance varies with temperature)
High voltage test DC500V 1 mA @ 2 sec
Rotor housing runout ≤0.1 mm
Steering (axle extension) clockwise
High temperature test Keep at 60°C for 100 hours; motor can work normally after 24 hours at room temperature
Low temperature test Keep at -20°C for 100 hours; motor can work normally after 24 hours at room temperature
Maximum power ≤60 W
Working current 4-6S
Working temperature -20~60°C; 10~90% RH

What’s Included

  • 3 x GM110-8 gimbal motor with AS5048A encoder & magnet
  • 1 x Alexmos 32BIT BGC board (encoder version, without aluminum case)
  • 1 x connecting cables set

Related Collections