T-Motor F411 AIO 1S 6A 4-in-1 ESC with ELRS 2.4G Receiver, 50mW Analog VTX/OSD, Bluejay

Overview

The T-Motor F411 AIO is a 1S 6A 4-in-1 ESC board integrating an STM32F411 flight controller, SPI ELRS 2.4G receiver, and an analog VTX with OSD. It is recommended for T-Motor M0803 / M0802 and supports direct plug-in motors (no soldering required); only the camera needs soldering.

Key Features

• STM32F411 FC (F4 FC chip): small area, low heat
• Integrated 6A 1S 4-in-1 ESC
• Pre-flashed Bluejay firmware (efficiency increased by 20% as stated)
• Integrated ELRS 2.4G receiver: SPI integrated, faster response, on-board antenna, small volume and strong signal
• Integrated 50mW analog VTX: UFL connector, replaceable antenna, switchable external VTX
• Integrated analog VTX OSD: on-board OSD chip for real-time flight information
• Direct plug-in motor connectors for simplified builds

For setup and compatibility questions (frames, motors, camera wiring), contact support@rcdrone.top or visit https://rcdrone.top/.

Specifications

What's Included

• Silicone shock-absorbing washer*6
• VTX antenna*1
• BT2.0 power cable*1

Applications

• 1S micro builds using T-Motor M0803 / M0802 motors
• Compact builds needing an all-in-one FC + 4-in-1 ESC + ELRS receiver + analog VTX/OSD

Details

T-Motor M0802/M0803 motors plug directly into the AIO board’s connectors for a clean, no-solder setup.

Simple camera soldering helps streamline wiring when building a compact FPV drone setup.

The STM32F411 F4 flight controller chip keeps the AIO board compact and designed for low heat in tight builds.

The integrated 6A 1S 4-in-1 ESC uses a compact AIO board layout with plug connectors and pre-flashed Bluejay firmware.

The integrated ELRS 2.4G receiver with an on-board antenna keeps the build compact and reduces extra wiring.

An integrated 50mW analog VTX with a UFL connector makes it easy to swap antennas or run an external VTX.

The integrated analog VTX and on-board OSD chip let you view key flight information in real time through your goggles.

Included accessories include six silicone shock-absorbing washers, one VTX antenna, and a BT2.0 power cable for installation.

The F411 AIO runs on 1S with 6A continuous (7A peak) current, a BMI270 gyro, SPI ELRS 2.4G V2.0, and a 48CH 50mW SmartAudio VTX in a 29.5×29.5mm, 6.7g board with 25.5×25.5mm M2 mounting.