Matek F411-WTE Flight Control With OSD / Racing FPV Quadcopter Flight Control For Racing Traversing Machine / Rc Drone Parts

FC specification:

MCU: 10OMHz STM32F411CEU6

IMU: BMI270 (SPI)

Air Pressure: SPL06-001 (I2C)

OSD: AT7456E (SPI)

Black box: no

2 UARTs

2x full soft serial

6 times PWM output (2 times motor, 4 times servo)

1x 12C

4x ADCs (VBAT, Current, RSSI, Airspeed)

3 LEDs (blue, red) and 3.3V indicator (red) for FC status

Built-in inverter for SBU input on UART2-RX

Switchable dual camera input

Vbat power switch available for VTX and camera

PPM Receiver: Not Supported

Parameter:

6~30v DC input (2~6S LiPo)

132A current sense (scale 250)

PDB/Current Sense Resistor: 9OA continuous, 132A burst.

BEC 5V 1.5A for FC and peripherals

BEC Vx 5A for Servo, 5V/6V option

Vbat for VTX and camera (can be turned on/off)

LD0 3.3V 200mA

Battery voltage sensor: 1k:10k

FC firmware:

INAV target: MATEKF411TE (INAV4.1 or newer)

Dimensions: 31 x 26 x 16.5mm

Mounting: 22 x 22mm, 2mm

Weight: 10 grams

included

1x FC F411-WTE

DuPont 2.54 pins (board shipped unordered)

MATEKSYS Flight Controller F411-WTE STM3ZFAIICEU6 IMU BMI27O Barometer SPLO6-001 OSD AT7456E 1 No Blackbox 2x UARTs, Zx Full Softserial Ix 12C 1 Ax ADC (Vbat; Current, RSSI , AirSpeed) 2x PINIO (Camera switch, Vbat switch) 132A current sensor (90A continuous)

Matek F411-WTE flight control system features an onboard serial module (BMI2ZO) with MPUGOOQ barometer, SPLOS-01 BMP280/DPS340 sensors, and SoftSerial 2x UARTs, along with 12 half-step PWM channels. It also includes 4 analog-to-digital converters (ADC) and 2+4 pulse-width modulation (PWM) outputs. Additionally, it comes equipped with a 13-pin sensor connector, including 7 analog inputs (78A) and 1 serial input (S46).

The Matek F411-WTE flight control features an onboard BEC with a maximum current output of 1.5A at 5V. The system does not supply voltage when connected via USB only, except for the following: the 4V/5V bus provides a stable output between 4.44 and 8V, with a maximum current draw of 80mA. Additionally, the unit includes an LED output that signals WS2812 data and a buzzer (Bz-ISR) that is activated when the system is in general active mode.

After reflashing the INAV Matek F411-WTE flight control, I experienced default settings returning to their original state (CLI defaults). To resolve this issue, ensure that both cameras use identical video formats - either PAL or NTSC.