light weight,small size MINI BODY strong performance Matchingwith T-MOTOR F4SA Mini 4INI ESC you will better flying experience

F7 73 842 Main Control Board features a BMI270 Gyroscope with low-noise and high-sensitivity capabilities.

The T-motor MINI F7 flight controller supports stable power supply for various peripheral devices, including receivers, analog cameras, analog video transmitters, and programmable LED light bars. Additionally, it provides power support for DJI's digital high-definition video transmitter (VTX) at 5V or 10V.

Easily adjust various On-Screen Display (OSD) parameters through the Flight Controller's software settings, for convenient setup and customization.

This flight controller supports various mainstream throttle signal formats, including D-Shot ISO, D-Shot 3000, D-Shot 6000, ProShot 1000, as well as being backward-compatible with OneShot125/OneShot425/Multishot and standard PWM signals.

Integrate the pit switch function to toggle the analog video transmitter on/off, enabling OBTP (One Button Turn Off and Power) operation remotely.

This product, the T-Motor MINI F7 Flight Controller, is designed for FPV RC drone racing quadcopters. It matches with T-Motor F4SA MINI 4INI ESC, providing a better flying experience. Key features include: input voltage of 3-6S; BEC capabilities of 2A (SV) and 3A (1OV); main control via STM32F722 processor; gyroscope accuracy from BMI270; onboard RAM of 16M; support for OSD; and no barometer integration. The mounting pitch is 20mm x 20mm, and the product weighs [insert weight]. Firmware is compatible with TMOTORF7.

T-Motor F722 Mini Flight Controller features current ESC options (ESC4, ESC2, and ESC1), battery voltage monitoring (+ and - pins), and supports J3 receiver output. It also includes PPM mode, DJI HD port, power input, and has adaptability for various receivers (Rx1, Rx2, Rx3).

The T-motor MINI F7 flight controller features a GRB R VTX pit mode solder joint, allowing you to control the on/off function via remote control. Additionally, this device can be connected to DJI Air units and matched with DJI remotes, which supports SBUS RX signals. The GND, TX, RX3, and VBAT pins have the following voltage range: 7.4V-17.6V.

Remember to configure your serial port (APOTTS or TAD) and select a baud rate of $FSERIAL, choosing UART3 with a speed of 115200.