MFE 12S 40A ESC For Makeflyeasy Fighter VTOL

Product Manual: MFE 12S 40A ESC For Makeflyeasy Fighter VTOL

Product Introduction

The MFE 12S 40A high-voltage ESC is deeply optimized according to the internal resistance and inductive reactance of the MFE 5015 KV160 motor, featuring smooth starting and efficient power output. Temporarily, it does not support other models of motors; using other motors may lead to starting jamming, high current blocking, and burning risks. Please use with caution.

Product Parameters

Tuning Process

1. Wiring Chart

   
   

    

2. Throttle Travel Tuning

   • Beeps - Throttle Calibration:
     • Power up:
       • Beep once
     • Throttle signal detected (arming sequence start):
       • Beep once
     • When throttle is above midstick (measuring max throttle):
       • Beeps while measuring
     • If throttle is above midstick for 3 seconds:
       • Long beep sequence indicates max throttle has been stored
     • When throttle is below midstick (measuring min throttle):
       • Beeps while measuring
     • If throttle is below midstick for 3 seconds:
       • Long beep sequence indicates min throttle has been stored

3. Normal Boot-up Process

   1. Turn on the remote control
   2. Connect the system to the battery; after 1 second, the motor emits "1-2-3" and then "1-" and "beep-" sounds, indicating the ESC is ready.

Assembly Process

1. Confirm the positive and negative wire sequence of the motor
   
   
2. Put the wire through the tube, then install the ESC
   
   
3. Install the heat sink silicone
   
   
4. Tighten the ESC cover screws
   
   

The MFE 12S 40A ESC is the ideal electronic speed controller for the Makeflyeasy Fighter VTOL, ensuring smooth motor startup and efficient power output. By following the detailed tuning and assembly guides above, you can easily install and calibrate your MFE 12S 40A ESC. Please strictly adhere to the operational procedures to ensure the safety and efficiency of the device.