SpeedyBee F7 V3 Flight Controller

SpeedyBee F7 V3 Flight Controller features a 32-bit processor and supports 3-axis acceleration, 3-axis gyroscope, and barometer sensors.

SpeedyBee F7 V3 Flight Controller: Compact design with dimensions 38mm x 30.5mm x 8.8mm, weighs only 13g. Equipped with LED lights, barometer, accelerometer and gyro. Supports SD cards up to 32GB. Includes features like autonomous flight modes, one-shot mode and more.

The SpeedyBee F7 V3 Flight Controller product image provides a detailed view of its components. To better recognize the wires, we've labeled some of them with letters from A to F. Please find the correct wires according to their corresponding letters: Cable A (3cm) or B (6cm).

Important Notice for SBUS Receiver: When using an SBUS receiver, connect the SBUS signal wire from the receiver to the SBUS port on the front side of the flight controller (which internally uses UART2). If you are also using a DJI Air Unit (V1), disconnect the SBUS signal wire from the Air Unit harness. Failure to do so may prevent the SBUS receiver from being properly recognized by the flight controller. Important Notice for ELRS Receiver: We recommend connecting the ELRS receiver TX and RX wires to T2 and R2 on the flight controller. However, when using a DJI Air Unit simultaneously, some ELRS receivers may not be recognized properly by the flight controller. If this issue occurs, disconnect the SBUS signal wire from the Air Unit harness.

SpeedyBee F7 V3 Flight Controller Product Image: Cable Connection vs DJI Air Unit Use - Comes with the 6-pin cable and F7 V3 stack (See accessory No.3 in the package section). Supports SBUS, GND, and L/R signals. Compatible with DJI Air Unit V1 and other systems.

SpeedyBee F7 V3 Flight Controller. Layout: FPV Cam (Analog) Receiver, 4-in-1 ESC, Sv G CAMCCIRS3V3 G4V5_RZT2 Barometer (BMP280), R3 T3 G M5 M6 M7 M8 TLML MCU: F722 @ 8 8 USB Type-C Port. Features include 4-level EDOattery, Antenna, Orange LED, Red LED, Boot Button, Blue LED, and Betaflight LED VTX (Analog/DJI) Buzzer Receiver. Also included are an FPV Camera, GV1, and 34CT CC LEDG LED2 22 {c @m G Sv} TVS Diode IV5 6 0 %oe#d BlackBox Flash (Anti-Voltage Spike), GG GPS Gyro (BMI270), 9V 4A BEC, LED3 LEDI OSD Chip (AT7456E) Analog VTX (SV) DJI Air Unit LED Indicator Definition: Red LED Power Indicator, Solid Red after powering up. Green LED Bluetooth status light. Solid Green indicates Bluetooth is connected. Blue LED Flight controller status light which is controlled by the flight controller firmware. Orange LED LED Control Mode Indicator.

SpeedyBee F7 V3 Flight Controller, 4-motor version. Equipped with CNC heat sink and capacitors for improved stability. Features include 8-pin connector to FC, +12V input, and power inductor. The board uses EDB and EEEB driver chips and MCUs.